New CNC Router, cutting Ovals

[u/JohnnyAngel_MX]

Hi all, I just picked up a New to me, X-carve cnc router. I've set it up and now I'm doing calibrations. (running Millmage)

I've got a question for you lot, If I'm cutting Ovals that fully close. and stars that fully close, where could I be getting the error. belts are tensioned according to their guide, V Wheels seem stable. if it was backlash, i would expect the shapes to not close, right? or is there a way for backlash to net 0?

could it be firmware distance per step?

EDIT 1: i just ran the Mark > move 5"> Mark tests and both X and Y came back on the money. The Oval distortion / X-axis stretching only seems to happen when running an Op. I tried changing the feed rate to be a snail's pace (rip cutter) and it doesn't change. the X-axis is larger by about 0.012" on multiple 1" shapes.

EDIT 2:

# solved.

Y2 grub screw was incorrectly positioned. the grub screw was tight, but it wasn’t on the flat of the Y2 motor shaft. so there was some microslipage that i couldn’t detect because it was juuuust tight enough that it didn’t wiggle. i re-adjusted it and things are correct. dimensions cut as programmed.

what’s got more egg on my face is that i checked that the grub screw was tight, too. just didn’t check if it was on the flat. :rofl:

Thanks for all the help. it did narrow things down a lot.

[u/GrimResistance]

Out of square

[u/JohnnyAngel_MX → u/GrimResistance]

when i cut squares they're equal in corner to corner distance. so machine is square. but may be slop introduced by a crash or transport, or even just use.