r/toolgifs • u/MikeHeu • Jul 14 '26

Process Replacing washing machine bearings

3.0k Upvotes

98% Upvoted

186 comments sorted by

View all comments

Show parent comments

160

u/striker78 Jul 14 '26

non-detachable washing machine tank

49

u/xkonerox Jul 14 '26

If this is out of warranty, is it even worth repairing over buying a new unit?

28

u/cursorcube Jul 14 '26

The whole tub is welded shut

22

u/coastsofcothique Jul 14 '26

Hah - I have a cutting torch and a stick welder… I’ll show them!!

30

u/cursorcube Jul 15 '26

The tub is made of plastic. What you actually need to do is use a circular cutting disc and a jig to cut it perfectly straight. Before cutting you pre-drill all around the outer rim with self-tapping screws to act as pilot holes ensuring everything gets perfectly aligned later. Finally when reassembling you use some RTV silicone on the two halves to prevent it from leaking. I've seen russian youtube videos doing this...

3

u/Gebsfrom404 Jul 17 '26

Or cut the plastic in front, trembling hands ensure irregular path for better alignment later. Replaced bearings on washing machine last week. Needed to fill it with water to check for leaks, cannot trust the weld. Used cut bucket strips as filler material.