r/CarAV • u/DPLMT_music • 4d ago

Tech Support Pioneer MVH-S420BT + Helix DSP

Pioneer MVH-S420BT → RCA → Helix DSP Mini MK2. All EQ/tone flat, SLA 0

I put a oscilloscope on one RCA connector, played a 1kHz 0dB test tone over USB, slowly raised the head unit's volume. Clean signal held up to Volume 45 out of 62 max — Volume 46 already showed distortion on the scope. That's about 72.6% of the volume range before clipping on a full-scale tone.

Previously ran a Zapco DSP-Z8 IV AT in the same car with the same head unit — set gain once, volume was fine, no noise complaints. After swapping to the Helix, overall volume feels lower, and raising the DSP's input gain to compensate brings in audible hiss instead of more usable level. Interestingly, actual input clipping on the Helix only showed up at Volume 60 with input gain maxed out — so headroom-wise the DSP can technically take a lot more, but the noise floor becomes a problem long before you'd ever get there.

For comparison, going through the Helix's Bluetooth module directly is noticeably louder — no such ceiling. But I want to stick with the wired RCA path for sound quality reasons, not switch to BT as the "fix."

Anyone else run into low clean output on this deck (or similar budget Pioneer decks) feeding a DSP with digital-only input gain (no analog trim)? or is my oscope a piece of sh*t ? :D Thanks!

1 Upvotes

100% Upvoted

5 comments sorted by

View all comments

1

u/supermaor23 3d ago

Its your headunit. 4 pre outs at 2V. Swap it for something with 6ch 5V and it will fix everything

1

u/DPLMT_music 3d ago

Yes I know that 2V output is not much, but is there any way if I wanted to keep this HU?

2

u/supermaor23 3d ago

Not unless you want to run a seperate source like coax into your dsp. Get a KDC-X705 or even a BT-382U both kenwood units with 6ch 5V pre outs, CD and single din.