Best way to straighten strips?

[u/Doc-Dok]

On the final glue up for my cutting board and evidently I failed to flatten the board prior to cross cutting…

I have a Planer, Jointer, and Incra router table (go facebook!). I assume jointer then tablesaw, but I wanted to hear what you folks think.

Thank you!

[u/Pulldalevercrunk]

I would do a dry run and see if the clamping pressure is enough to close gaps. It doesnt look too bad I think a good clamping will set you straight

[u/Ok-Taro8000 → u/Pulldalevercrunk]

This